This fits your .
Enter your model number
to make sure this fits.
Optical Port: 100Mbps, Single SC singlemode fiber, support 100M Ethernet.
RJ45 Port: CAT5E/CAT6 10M/100M, Full Duplex or Half Duplex; Supports MDI/MDI-X auto crossover.
Status LED's for TX, FX LINK/ACT, POWER, FDX to easily monitor network status.
Complies with IEEE IEEE 802.3/802.3u/802.3af.
Supports wide temperature range from -20°C to 70°C.
1310nm Single mode
Transfer Distance: up to 20km
Connectors: Single SC connector
Fiber core: 8.3um, 8.7um, 9um and 10um on single mode fiber
Optical Power (dBm): -15~ -8
Receiving Sensitivity (dBm): ≤-34
In accordance with Ethernet standards IEEE802.3 10Base-T, IEEE802.3u 100Base-T and 100Base-FX
Supported Ports: SC for optical fiber; RJ45 for twisted pair
Auto-adaptation rate and full/half-duplex mode supported at twisted pair port
Auto MDI/MDIX supported without need of cable selection
Up to 6 LEDs for status indication of optical power port and UTP port
External DC power supplies provided
128 K's data buffer RAM
Support for low-delay time pure data transmission and full/half-duplex flow control
Built-in -dog timer to monitor any error in internal data exchange
FX, TX, Link/Act(Left/Right), FDX, PWR
FX: Light on when fiber speed is 100Mbps, while “OFF” means the rate is 10 Mbps
TX: Light on when TP speed is 100Mbps, while “OFF” means the rate is 10 Mbps
Link/ACT: Left side is indicate for fiber port link/act and right side for TP,light flashing when data transmitting and receiving
FDX: Light on when TP full-duplex mode is active,light off when TP half-duplex mode is active
PWR: Light on when DC power on, else light off
Output voltage: AC 220V or DC5V 1A
Power dissipation: ≤1 watts
Housing: Metal enclosure
Volume: 94x70x26mm (LxWxH)
Operating Temperature: 0°C to 50°C
Storage Temperature: -20°C to 70°C
Humidity: 5% to 90% RH
10/100Mbps a Pair of Media Converters up to 20KM Bi-Directional single-mode SC fiber 10/100Base-TX to 100Base-FX ipolex - B071DP46G3