Covers power surge and other mechanical and electrical breakdowns.
No deductibles or hidden fees. Free shipping on all repairs. Fully transferable.
Easy claims process online or by phone 24/7. If we can't fix it, we will send you an Amazon e-Card for full replacement value.
Coverage begins date of purchase and is inclusive of the manufacturer's warranty. Plan is fully refunded if canceled within 30 days.
Plan contract will be emailed from Asurion within 48 hours of purchase. This will not ship with your product.
User Guide: http://osoyoo.com/2016/07/28/mks-hlkwifi/
1. Due to undercurrent, MKS HLKWIFI can not work with Ramps1.4
2. Cannot send files from the wifi module, only applied to control.
3. By default, Wifi module baud rate is 115200, firmware baud rate settings must be set to the same.
1. Connect to Aux-1 of MKS TFT touch screen.
2. Connect to Aux-1 on MKS BASE, MKS MINI, MKS SBASE, MKS GEN.
Notice: MKS BASE only supports V1.2 updated version.
1. MKS TFT can support MKS WIFI module.
2. After MKS TFT works with MKS WIFI module, can use Printrun, Repetier-Host to proceed remote connect and control. But it may make some functions unavailable.
mks_config.txt basic configuration:
1. Configuration on single and double nozzle : change the value after the colon of “cfg_sprayer_counter” into the nozzle you need.(“1”is single nozzle; “2” is double nozzle )
2. Heated bed configuration: change value after the colon of “cfg_custom_bed_flag” into custom requirements you need.(“1” is with heated bed; “0” is without heat bed)
1* MKS HLKWIFI WIFI Module
Gowoops 3D Printer UART WIFI Module MKS HLK-WIFI V1.1 Wireless Router for MKS TFT Touch Sreen and MKS Controller Board Remote Control Can Not Work With Ramps1.4 - B01N1U8D4L